TM 5-5420-202-20-2
TURBOSUPERCHARGER OIL DRAIN TUBE (LEFT BANK) REPLACEMENT (Sheet 1 of 3)
TOOLS: 1/2 in. socket with 1/2 in. drive
F l a t - t i p screwdriver
Ratchet with 1/2 in. drive
5/16 in. combination box and open end wrench
SPECIAL TOOLS: Ground hop kit (Item 31, Chapter 3, Section 1)
SUPPLIES:
Gasket
REFERENCE:
P R E L I M I N A R Y PROCEDURES:
Remove powerplant (page 5-2)
Drain engine oil (page 6-12)
REMOVAL:
1.
Using 1/2 inch socket, remove
two bolts (A) and two washers (B).
2.
Remove gasket (C).
3.
Throw gasket (C) away.
NOTE
If clamps (D) cannot be loosened using
screwdriver, use 5/16 inch wrench.
Using screwdriver, loosen six clamps (D)
4.
on three hoses (E), (F) and (G).
5.
Remove oil drain tube assembly (H) from
engine.
6.
Remove six clamps (D) and three hoses (E),
(F) and (G) from tubes (J) and (K).
INSPECTION:
1.
Inspect bolts (A) for stripped threads.
2.
Inspect hoses and hose clamps for general serviceability.
3.
Replace defective parts as required.
Go on to Sheet 2