TM 5-5420-202-20-2
AIR CLEANER INTAKE AND HOSE REPLACEMENT (Sheet 2 of 5)
1.
Using a 3/8 inch wrench, loosen clamp nut (A) at end of intake hose (B).
2.
Slide clamp (C) over intake hose (B) to middle of hose.
Using a screwdriver, pry hose (B) from elbow (D), remove clamp (C).
3.
Close top grille doors and go inside crew
4.
compartment.
Using a 1/2 inch socket, remove four screws
5.
and lockwashers (E).
6.
Remove cover and gasket (F).
7.
Inspect gasket cemented to cover (F). If
damaged, use a putty knife to remove gasket.
Apply adhesive to new gasket and position
onto cover.
8.
Using a 9/16 inch socket remove eight nuts
and lockwashers (G).
Remove air intake flange assembly (H) and
9.
hose (B).
10.
Inspect gasket (J) cemented to bulkhead.
If damaged, use a putty knife to remove
gasket. Apply adhesive to new gasket (J)
and Position on bulkhead.
Go on to Sheet 3
7-66