TM 5-5420-202-20-2
CONDENSATE RELIEF VALVE REPLACEMENT (LEFT OR RIGHT) (Sheet 2 of 2)
CLEANING AND INSPECTION:
Dry cleaning solvent P-D-680 is toxic and flammable. To prevent personal injury, wear
protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do not use near open flame or excessive heat. The
flash point for Type #1 Dry Cleaning Solvent is 100F (38C) and for Type #2 is 138F (50C).
If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.
If contact with eyes is made, wash your eyes with water and get medical aid immediately.
1. Using dry cleaning solvent and rags clean all components.
2. Inspect components for cracks or breaks. Replace unserviceable components.
3. Using 6 inch ruler as measure, replace spring if free length is less than 1 inch.
INSTALLATION:
1. Position three ball bearings (A), new preformed packing (B), and spring (C) on pipe
adapter (D).
2. Press connector sleeve (E) down on
pipe adapter (D). Using pliers,
install retaining ring (F).
Remove rags from fuel tank.
3.
4.
Using 1-3/4 inch wrench, install
pipe adapter (D) in fuel tank (G).
5.
Press down on connector
sleeve (E) and install plug (H).
6.
Using slip joint pliers, install
chain (J) on plug (H).
7.
Close top grille doors (TM 5-5420-202-10).
End of Task
7-132
