TM 5-5420-202-20-2
FUEL-WATER SEPARATOR OPERATIONAL TESTS (Sheet 11 of 11)
Sequential Drain Test (Sheet 4 of 4)
Using screwdriver, install clamp.
18.
Using 5/16 inch wrench, remove two pipe plugs from upper (A) and lower (S) sensor holes.
19.
20.
Using 1/2 inch wrench, install sensor retaining nut (T).
21.
Using 1/2 inch wrench to hold sensor retaining
nut (T), use 9/16 inch wrench to install upper
sensor (G) into fuel-water separator (D).
22.
Using 5/16 inch wrench, remove pipe plug from
lower sensor hole (S).
23.
Using 1/2 inch wrench, install sensor retaining
nut (U).
24.
Using 1/2 inch wrench to hold sensor retaining
nut (T), use 9/16 inch wrench to install lower
sensor (J) into fuel-water separator (D).
25.
Using 1/2 inch socket, close bleed cap (V)
until snug by turning clockwise.
26.
Position clamp (W) onto fuel-water separator
and, using 1/2 inch socket, install three
capscrews, lockwashers, and washers (X).
27.
Using 1/2 inch socket and extension, tighten
capscrew (Y).
28.
Install powerplant (page 5-14).
29.
Perform fuel system bleeding
procedure (page 7-63).
End of Task
7-233