TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 3 of 18)
Male Plug Repair (Sheet 2 of 3)
7.
Using hand wire stripper, strip insulation
from jumper wire equal to depth of
contact solder well (F).
8.
Placing connector face down on flat
surface, apply a small amount of silicone
to empty holes on back of plug assembly
(B) and on front of grommet (D).
Push new contact (E) into hole in back of
9.
plug assembly (B) far enough so it will
remain standing.
10.
Push jumper wire end, first through
grommet retaining nut (A) and then
through hole in grommet (D).
11.
Hold jumper wire so wire end is pushing
down on solder in contact solder well (F).
12.
Hold soldering gun tip against side of
contact (E) until solder begins to melt
and wire slips into contact solder well
(F).
13.
Removing soldering gun from side of
contact (E), continue holding wire until
solder has cooled and set.
TA249241
Go on to Sheet 3
10-300