TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS CABLE CONNECTOR REPAIR (Sheet 6 of 18)
Terminal Connector Repair (Sheet 1 of 2)
TOOLS:
Electrical connector repair tool kit
Diagonal cutting pliers
Heat gun
Pocket knife
Heat-shrink tubing (Item 60, Appendix D)
SUPPLIES:
Terminal
Disconnect three battery ground straps (page 10-268)
PRELIMINARY
PROCEDURES:
Loosen or remove cable clamps as required
1.
Using knife, slit heat-shrink tubing (A)
along its entire length. Throw heat-shrink
tubing (A) away.
2.
Using diagonal cutting pliers, cut terminal
(B) from cable (C). Throw terminal (B)
away.
3.
Using hand wire stripper, strip insulation
from cable (C) equal to well depth in
terminal (B).
Go on to Sheet 2