TM 5 - 5 4 2 0 - 2 0 2 - 2 0 - 3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 8 of 18)
Female Plug Repair (Sheet 1 of 3)
TOOLS:
Electrical
connector repair tool kit
gun
Slip joint
pliers with plastic jaw inserts
Diagonal
cutting pliers
Silicone compound (Item 32, Appendix D)
SUPPLIES:
Electrician's tape (Item 59, Appendix D)
Jumper wire
PRELIMINARY
PROCEDURES:
Disconnect three battery ground straps (page 10-268)
Loosen or remove cable clamps as required
Disconnect connectors at each end of affected cable
1. Manually remove grommet retaining nut (A)
from plug assembly (B).
2.
Slide grommet retaining nut (A) back
along cable (C).
3. Using slip joint pliers, work
grommet (D) back and forth and
out of plug assembly (B).
4.
Using remover, push contact (E)
with damaged wire out of back
of plug assembly (B).
Go on to Sheet 2