TM 5-5420-202-20-3
SHIFTING FORWARD OUTBOARD ROD REPLACEMENT (Sheet 3 of 4)
ADJUSTMENT:
NOTE
When adjusting rod end, make certain
that threads on control rods extend past
the gage opening in the rod end to ensure
a positive grip.
1.
Using two 9/16 inch wrenches and steel tape, adjust rod end bearing (A) to obtain same
center-to-center distance between holes in rod end bearing (A) and clevis (B) as measured
and recorded in steps 3 and 4, REMOVAL.
2.
Using torque wrench and crowfoot adapter, tighten nut (C) against rod end bearing (A) to
16-18 lb-ft (23-24 Nm).
Go on to Sheet 4
TA249298