TM 5-5420-202-20-3
SHIFTING CONTROL REAR ROD AND LEVERS REPLACEMENT (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
TOOLS:
Slip joint pliers
7/16 in. open end wrench
9/16 in. open end wrench (2 required)
Flat-tip screwdriver
SUPPLIES:
Spring pin
PRELIMINARY
PROCEDURES:
Block tracks to prevent vehicle movement
Place shift lever in reverse (TM 5-5420-202-10)
Remove top deck (page 16-21)
Remove transmission shroud (page 9-2)
REMOVAL:
1.
Using pliers, remove cotter pin (A) from
transmission shaft stud (B).
2.
Using 9/16 inch wrench, remove nut
and washer (C) from transmission shaft
stud (B).
Go on to Sheet 2