TM 5-5420-202-20-3
SHIFT LINKAGE ADJUSTMENT (Sheet 25 of 28)
TOP OF TRANSMISSION
132.
Using small diameter wire, check to see if
shifting rod (BV) is past holes (BW) and
(BX). If shifting rod (BV) is past holes
(BW) and (BX), do steps 133 thru 136. If
shifting rod (BV) is not past hole (BW),
do steps 137 thru 146. If shifting rod (BV)
is not past hole (BX), go on to step 147.
133.
Using 9/16 inch wrench, install screw (F)
through clevis (H) and shifting rod bearing
end (G).
Holding rod bearing ends (G) and (BY) with
134.
9/16 inch wrench, use torque wrench and
9/16 inch crowfoot adapter to tighten jamnuts
(BT) and (BU) to 16-18 lb-ft (22-24 Nm).
RIGHT REAR OF VEHICLE
135.
Remove locating pin from alinement hole (C).
136.
Using torque wrench and 9/16 inch socket, tighten screw (F) to 16-18 lb-ft (22-24 Nm)
and go to step 156.
Go on to Sheet 26
TA249342
11-76
