TM 5-5420-202-20-3
SHIFT LINKAGE ADJUSTMENT (Sheet 28 of 28)
NOTE
It may be necessary to move indicator pointer to
rear most positioned dot to adjust rod end, and
then back to forward most positioned dot to check
adjustment in step 152.
Using 9/16 inch wrench, adjust shifting rod
152.
bearing end (G) by turning clockwise or
counterclockwise until screw (F) will drop
freely through clevis (H) and shifting rod
TOP OF TRANSMISSION
bearing end (G).
Using 9/16 inch wrench, install screw (F) through clevis (H) and shifting rod bearing end
153.
(G).
Holding rod bearing end (G) with 9/16 inch wrench, use torque wrench and 9/16 inch
154.
crowfoot adapter to tighten jamnut (BT) to 16-18 lb-ft (22-24 Nm).
Using torque wrench and 9/16 inch socket,
155.
tighten screw (F) to 16-18 lb-ft (22-24 Nm).
Remove blocks from tracks.
156.
Check shifting pattern response (TM 5-5420-
157.
202-10). If transmission still does not shift
correctly, notify support maintenance.
If transmission does shift correctly, go on
to step 158.
158.
Install top deck (page 16-23).
159.
Install transmission shroud (page 9-6).
TA249345
End of Task
11-79
