TM 5-5420-202-20-3
PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (REAR ONLY OF TWO-PIECE) (Sheet 6 of 6)
11. Position connector (M) in bellcrank assembly (R). Using a 9/16 inch socket and extension,
install bracket (G) to bracket assembly (S) with two screws (T) and lockwashers (U).
NOTE
Pin and clip securing connector (M) to bellcrank
(R) need not be installed until adjustment proce-
dure is performed.
CAUTION
Make sure control assembly (C) is secured to hull
wall with clamp (N) located on metal casing, 1 inch
below disconnect nut (D).
Using adjustable wrench on flats of control assembly (A), and torque wrench with 7/8
12.
inch crow foot tighten disconnect nut (D) to 35-50 lb-in (3.9 to 5.7 N.m).
13. Perform parking brake control assembly
adjustment (page 13-132).
END OF TASK
TA249511
13-127