7/16 in. socket with 1/2 in. drive
Pry bar
Slip joint pliers
Gage block, 3/16 inch
FABRICATED TOOLS:
Gage block, 15/16 inch
Gage block, 1-1/8 inch
Locating pin (1/8 in. drill or welding rod 4 in. long)
SUPPLIES:
Cotter pin (4 required)
Gasket (2 required)
Lockwasher (8 required)
PRELIMINARY PROCEDURES: Remove powerplant (page 5-2)
NOTE
If your vehicle is equipped with the two-piece control assembly, it must
be separated at the disconnect.
ADJUSTMENT:
Using socket, remove eight nuts and lockwashers (A) securing cover and gasket (B) tO
1.
brake housing assembly (C). Remove cover and gasket. Throw gaskets and Lockwashers
away.
TA249520