TM 5-5420-202-20-3
PARKING BRAKE PAWL AND BELLCRANK ADJUSTMENT (Sheet 3 of 9)
At side housing assembly, hold control (G) at flats using oPen end of 9/16 in. wrench and
4.
loosen jam nut (H) with a 15/16 in. wrench. Continue holding control (G). Finger tighten
nut (J) until nut bottoms on control (G). Tighten nut (H) with a 15/16 in. wrench.
CAUTION
Do not tighten nut (J) with wrench as shaft (K) to
control (G) binding will occur. Finger tighten nut
Push and pull on clevis (F) to verify
5.
shaft (K) movement is free of binding.
If free movement occurs, proceed to
next step. If binding occurs, back-off
sleeve nut (J). Visibly inspect pack-
ing (L) for damage. Refer to page 3-70
for removal procedure.
DO NOT REPLACE PACKING. When
complete, repeat step 4.
TA249522
Go on to Sheet 4
13-138