TM 5-5420-202-20-3
PARKING BRAKE CABLE ADJUSTMENT (Sheet 3 of 4)
7.
Using ruler, measure distance between
nut (L) and connector (M) after brake
cable (G) is pushed inward as far as
possible. Record reading.
Pull brake cable (G) outward 3/4 inch
8.
farther than reading taken in step 7.
NOTE
Do not change 3/4 inch position
when performing step 9.
If pin cannot be freely inserted in connector
9.
(M), using 15/16 inch wrench, loosen
two nuts (N) and adjust cable travel
maintaining distance in step 8 until
connector (M) and bellcrank (H) will
aline. Tighten two nuts (N) after inserting
pin and clip. Tighten nuts (N) to 45-
50 lb-ft (61-68 N.m).
NOTE
An interference may exist between clevis and locating
pin during this adjustment procedure. It may be
necessary to grind clevis as shown to eliminate this
TA249518
Go on to Sheet 4
13-134