TM 5-5420-202-20-3
ROADWHEEL ARM REPAIR (Sheet 9 of 9)
Apply grease to bearing spacer (E) and bearing washer (F).
15.
Install bearing spacer (E) onto spindle up against outboard bearing (C),.
16.
17.
Repeat step 14 to install inboard bearings (D).
17.1 Install bearing washer (F) onto spindle up against inboard bearing (D) with step side of washer (F)
facing bearinga (D).
Install key washer (G) on spindle of arm so that inside tab fits into groove.
18.
N OT E
M a k e sure out e r t a bs of k e y w a she r a re point ing t ow a rds nut (H ).
19.
Screw nut (H) onto threaded end of spindle.
20.
Using spanner wrench, tighten nut (H) until
parts on spindle cannot be turned by hand.
21.
Back off nut (H) just enough so parts can be
turned by hand through one complete turn on
spindle.
Using pliers, bend tab on key washer (G) into
22.
alining slot on nut (H).
23. Install roadwheel arm (page 14-6).
End of Task
Change 4
1 4 -1 4 .3 /(1 4 -1 4 .4 blank)