TM 5-5420-202-20-3
HUB ASSEMBLY REPLACEMENT (Sheet 4 of 7)
4.
Inspect bearings and cups for damage. Replace
as necessary.
5.
Check seal assembly for rust, missing rivets, or
other damage. Replace seal as required using
seal inserter.
6.
Inspect all nuts, washers, and screws for
wear and damaged threads.
7.
Inspect spacer on spindle for scratches, nicks,
or dents. If damaged, notify support
maintenance.
ASSEMBLY:
1.
Grease both bearing cups. Position bearing
inserter set (Item 17, Chapter 3, Section I) to
inner cup (A) in hub (B).
2.
Using hammer, tap remover-replacer to seat
inner cup (A) into place in hub (B).
3.
Using bearing inserter set (Item 18, Chapter 3,
Section I) repeat steps 1 and 2 to seat outer cup
(C) in hub (B).
Go on to Sheet 5