TM 5-5420-202-20-3
TRACK ASSEMBLY REPLACEMENT (Sheet 1 of 10)
PROCEDURE INDEX
PROCEDURE
I PAGE
Removal
Installation
TOOLS: Sledge hammer
15/16 in. socket with 3/4 in. drive
Hinged handle ('breaker' bar) with 3/4 in. drive
Ratchet with 3/4 in. drive
2 lb hammer
Crowbar, pinch point
1-5/16 in. socket with 3/4 in. drive
1-1/2 in. socket with 3/4 in. drive
Torque wrench with 3/4 in. drive (0-600 lb-ft) (0-814
10 in. extension with 3/4 in. drive
Track end connector puller and pump (Item 37, Chapter 3, Section I)
SPECIAL TOOLS:
Track torquing tool kit (Item 11, Chapter 3, Section I)
Track connecting fixture (Item 19, Chapter 3, Section I)
SUPPLIES Rope (Item 66, Appendix D) (50 ft.)
Three
PERSONNEL:
REFERENCES:
Loosen track tension (TM 5-5420-202-10)
PRELIMINARY
PROCEDURE:
Remove rear fender and shield (if required) (page 16-69)
Go on to Sheet 2
Change 4