TM 5-5420-202-20-3
FENDER AND SHIELD (REAR) REPLACEMENT (Sheet 1 of 7)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Installation
T O O L S :: 1-in. socket with 1/2 in. drive
9/16 in. socket with 112 in. drive
Ratchet with 1/2 in. drive
7/16 in. socket with 1/2 in. drive
9/16 in. combination box and open end wrench
7/16 in. combination box and open end wrench
5 in. extension with 1/2 in. drive
1/2 in. combination box and open end wrench
Torque wrench with 1/2 in. drive (0-175 lb-ft)
Handle, socket wrench, hinged, 1/2 in. drive
SUPPLIES: Lockwasher (9 required)
Locknuts (8 required)
REMOVAL
NOTE
Right rear removal is
Left rear fender and shield shown.
similar.
1.
Using 9/16 inch socket on five screws (A) and 9/16 inch wrench on nuts (B) remove five
screws (A), washers (C), lockwashers (D), and nuts (B) holding fender (E) to angle (F).
Go on to Sheet 2
