TM 5-5420-202-20-4
BULKHEAD P TO RING REPLACEMENT (Sheet 1 of 1)
TOOLS: 7/16 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
Putty knife
Gasket
SUPPLIES:
Adhesive (Item 4, Appendix D)
Lockwashers (12 required)
Self-locking nut (8 required)
PRELIMINARY PROCEDURE: Remove universal joint (TM 5-5420-228-24)
REMOVAL
Using socket, remove eight self-locking nuts (A) from ring (B).
1.
Using socket, remove 12 screws and lockwashers (C), securing ring (D) and gasket (E) to
2.
cover (F).
Remove rings (B) and (D), and gasket (E). Throw gasket away.
3.
Using putty knife, scrape off all gasket and adhesive residue.
4.
INSTALLATION:
Apply adhesive to surface (G) and surface (H) of new gasket (E).
1.
Position rings (B) and (D), and gasket (E) on cover (F) with holes alined.
2.
Using socket, install 12 screws and lockwashers (C) securing ring (D) and gasket (E) to
3.
cover (F).
Using socket, install eight nuts (A) securing ring (B) and gasket (E) to p to housing.
4.
Install universal joint (TM 5-5420-228-24).
5.
TA248546
End of Task