TM 5-5420-202-20-4
REAR DRAIN VALVE MOUNTING BRACKETS REPLACEMENT (Sheet 2 of 2)
Using socket, remove four screws (D), four
3.
lockwashers (E), and two washers (F) attaching
large bracket (G) to small bracket (H) and
small bracket (H) to hull floor (J)
●
Slide large bracket (G) off rod (K).
4.
INSTALLATION
Using socket, install two screws (A), lockwashers (B), and flat washers (C) through oval-
1.
shaped holes in small bracket (D) into holes in large bracket (E).
Slide large bracket (E) on rod (F).
2.
Using socket, install two screws (G) and
3.
lockwashers (H) attaching small bracket (D)
to hull floor (J).
Using 9/16 inch wrench, install jamnut (K)
4.
all the way on rod (F).
Screw clevis (L) on rod (F) the recorded
5.
number of turns (page 17-38, NOTE).
Using 9/16 inch wrench, tighten jamnut (K)
6.
against clevis (L) while holding clevis (L)
with pliers.
Install actuating lever (page 17-36).
7.
TA248570
End of Task
17-39