TM 5-5420-202-20-4
REAR DRAIN VALVE LINKAGE ADJUSTMENT (Sheet 2 of 7)
5.
Adjust clevis (C) until holes in clevis and hole
in lever (F) can be lined up using clevis pin (B).
6.
Using fingers, tighten jamnut (G) against clevis
Measure threads on rod (H):
7.
If threads measure one inch or less, go to
step 14.
If threads are more than one inch, go to
step 8.
NOTE
Coupling jamnut (J) can be reached from engine compartment.
Open or close rear drain valve, if necessary, to put wrench on
coupling jam nut (J).
Using wrench, loosen coupling jamnut (J) all the way while holding coupling (K) with another
8.
wrench.
TA248572
Go on to Sheet 3
17-41