TM 5-5420-202-20-4
EXTERIOR RELEASE HANDLE BODY ASSEMBLY REPAIR (Sheet 1 of 1)
Ball peen hammer
TOOLS:
1/8 in. flat-tip screwdriver (pocket screwdriver)
1/2 inch drive punch
Drive screws (2 required)
SUPPLIES:
Remove release handle body assembly (page 20-39).
PRELIMINARY PROCEDURE:
DISASSEMBLY:
1.
Using screwdriver, pry two drive screws (A) from body (B).
2.
Remove two clip springs (C).
3.
Replace defective parts as required.
ASSEMBLY:
1.
Place body (B) on flat surface.
Position clip springs (C) onto body (B).
2.
3.
Using hammer and punch, tap new drive screws (A) into body (B).
4.
Install release handle body assembly (page 20-41).
TA248701
End of Task