TM 5-5420-202-20-4
EXTERIOR RELEASE HANDLE MOUNTING BRACKET REPLACEMENT (Sheet 1 of 2)
TOOLS:
1-1/8 in. combination box and open end wrench
1 in. combination box and open end wrench
Flat-tip screwdriver with 5/16 in. blade
SUPPLIES:
Preformed packing (two)
PRELIMINARY PROCEDURES:
Remove exterior release handle body assemblies
Remove outside release handle control assemblies
REMOVAL:
Using 1-1/8 inch wrench, remove two
1.
nuts (A) from inside hull.
2.
Remove mounting bracket (B) from
vehicle.
3.
Using hands, remove preformed packings
(C). Throw packings away.
NOTE
Using 1 inch wrench, remove couplings
4.
(D) from mounting bracket (B).
When removing couplings (D) in next step,
bushings (E) and washers (F) will remain with
Using 1-1/8 inch wrench, remove nuts
5.
couplings (D).
(G) from mounting bracket (B).
Using screwdriver, remove washers (F) and bushings (E) from couplings (D).
6.
Go on to Sheet 2
TA248706