TM 5-5420-202-34
POWER TAKEOFF REPAIR (Sheet 2 of 8)
DISASSEMBLY:
1.
Using flat-tip screwdriver, carefully
pry fuel pump adapter (A) from power
takeoff housing (B).
2.
Remove preformed packing (C) from
pump adapter (A). Throw packing away.
3.
Using stud remover/installer, remove
four studs (D) from power takeoff housing
(B).
4.
Using 7/16 inch socket, remove eight
self-locking nuts (E), washers (F), and
flange (G) from studs (H).
5.
Using 1/2 inch socket, remove eight
self-locking nuts (J) and washers (K)
from studs (L).
Install two 1/4-NC x 1 inch jackscrews into two threaded holes in adapter (M).
6.
7.
Using 7/16 inch socket, tighten jackscrews alternately until adapter (M) comes away from
power takeoff housing (B).
8.
Remove adapter (M) from power takeoff housing (B).
3-15
