TM 5-5420-202-34
POWER TAKEOFF REPAIR (Sheet 6 of 8)
6.
Install pinion ring gearshaft (D) into
power takeoff housing (A).
7.
Using stud remover/installer, install
eight studs (E) into power takeoff housing
(A).
8.
Using arbor press, support
bearing (F) and press shaft (G)
into bearing (F).
Using external retaining ring pliers,
9.
install retaining ring (H) onto shaft
(G).
Position adapter (J) with gasket surface
10.
down.
11.
Using brass punch and hammer, install
seal (K) into adapter (J) by alternately
driving sides of seal (K).
12.
Using arbor press, support front adapter (J) with gasket surface facing up and
press bearing (F) with shaft (G) into adapter (J).
13.
Using internal retaining ring pliers, install ring (L) into adapter (J).
Go on to Sheet 7
3-19
