TM 5-5420-202-34
FUEL PRIMER PUMP PISTON ROD ASSEMBLY REPAIR (Sheet 3 of 3)
ASSEMBLY:
Place clevis (A) in position on piston rod (B). Aline holes.
1.
Using hammer, install pin (C).
2.
Install two new packings (D) on piston rod (B)
3.
4.
Install two new packings (E) inside gland (F).
Install new packing (G) onto gland (F).
5.
Slide gland (F) on piston rod (B).
6.
Slide piston (H) on piston rod (B).
7.
8.
Install two new packings (J).
Using 7/16 inch wrench, install flat
9.
washer (K) and nut (L) on piston rod
(B) while holding clevis (A) with adjustable
wrench.
10.
Using pliers, install cotter pin (M).
Install piston rod assembly in primer
11.
pump (page 4-81, steps 3-4 and page
End of Task
