TM 5-5420-202-34
SHIFTING CONTROL CONNECTING LINK REPLACEMENT AND REPAIR (Sheet 1 of 3)
TOOLS:
Hammer
1/8 in. drive punch
5/8 in. combination box and open end wrench (2 required)
Vise
Pin (2 required)
SUPPLIES:
REFERENCE:
TM 5-5420-202-20
PRELIMINARY
PROCEDURES:
Remove shifting control sleeve (page 6-5)
Disconnect control rod at rear link assembly (TM 5-5420-
202-20)
REMOVAL:
Using hands, pull shaft (A) forward until shaft (B) is exposed at bulkhead.
1.
Using 5/8 inch wrench to hold jamnut (C), use another 5/8 inch wrench on plug (D) to
2.
remove shaft assembly (A).
Go on to Sheet 2
6-2
