TM 5-5420-202-34
SHIFTING CONTROL CONNECTING LINK REPLACEMENT AND REPAIR (Sheet 2 of 3)
Position shaft (A) in vise and, using hammer and punch, remove pin (E) from universal
3.
joint (F). Throw pin (E) away.
4.
Using hammer and punch, remove pin (G) from universal joint (F). Throw pin (G) away.
5.
Remove plug (D) from universal joint (F).
6.
Remove shaft (A) from universal joint (F).
7.
Inspect shaft (A), universal joint (F), and plug (D) for looseness and wear. Replace defective
parts.
INSTALLATION:
1.
Position shaft (A) in vise and, using hammer and punch, install new pin (B) into universal
joint (C) and shaft (A).
2.
Position plug (D) into universal joint (C) and, using hammer and punch, install pin (E)
into universal joint (C) and plug (D).
Go on to Sheet 3
6-3
