TM 5-5420-202-34
SHIFTING CONTROL SLEEVE ASSEMBLY REPLACEMENT AND REPAIR (Sheet 2 of 4)
3.
Using 9/16 inch wrench, remove nut
(D) from bulkhead shaft (E).
4.
Using 7/16 inch wrench on screw locking
nuts (F) and key on screw (G), loosen
and remove nuts (F) and screws (G).
5.
Slide sleeve assembly (H) toward front
of vehicle and off shaft (E).
DISASSEMBLY:
1.
Using 5/16 inch wrench, remove grease fitting (A) from sleeve (B).
Position sleeve (B) in vise. Using hammer and bearing installation and removal tool,
2.
remove two seals (C) and bearing (D) from sleeve (B). Throw seals (C) and bearing (D)
away.
Go on to Sheet 3
6-6
