TM 5-5420-202-34
SHIFTING CONTROL SLEEVE ASSEMBLY REPLACEMENT AND REPAIR (Sheet 3 of 4)
ASSEMBLY:
1.
Position sleeve (A) in vise. Using hammer and bearing installation and removal tool,
install new seal (B) into sleeve (A) with lip facing outward. Make sure the front part
of seal (B) measures 2-3/8 inches from the front of sleeve (A).
2.
Using hammer and bearing installation and removal tool, install new bearing (C) into
sleeve (A). Make sure bearing fits snug against seal (B) and is 11/16 inch from the front
of sleeve (A).
3.
Using hammer and bearing installation and removal tool, install new seal (D) into sleeve
(A) with lip facing outward.
Using 5/16 inch wrench, install new grease fitting (E) into sleeve (A).
4.
Go on to Sheet 4
6-7
