TM 5-5420-202-34
SHIFTING CONTROL SLEEVE ASSEMBLY REPLACEMENT AND REPAIR (Sheet 1 of 4)
PROCEDURE INDEX
PAGE
PROCEDURE
6-5
Removal
Disassembly
6-6
Assembly
6-7
Installation
6-8
Torque wrench with 1/2 in. drive
TOOLS:
6 in. rule
(0-175 lb-ft) (0-237 N . m)
5/16 in. combination box and
9/16 in. crowfoot wrench with 1/2 in.
open end wrench
drive
7/16 in. combination box and
9/16 in. socket with 1/2 in. drive
open end wrench
7/16 in. crowfoot wrench with 1/2 in.
9/16 in. combination box and
drive
open end wrench (2 required)
1/8 in. key
Hammer
Vise
LO 5-5420-202-12
REFERENCES:
TM 5-5420-202-20
Seals (2 required)
SUPPLIES:
Bearing
FABRICATED TOOL: Bearing installation and removal tool (Figure D-2, Appendix D)
REMOVAL:
1.
Using 9/16 inch wrench, remove screw (A) securing front intermediate rod (B) to bulkhead
shaft rod end (C).
2.
Using 9/16 inch wrench to hold nut (D), use 9/16 inch wrench and remove rod end (C).
Go on to Sheet 2
