TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 13 of 30)
NOTE
Before completing disassembly, perform cleaning and
inspection of case, carrier, and gears.
Clean gasket surfaces, as necessary, using putty knife or gasket scraper.
61.
Dry cleaning solvent P-D-680 is toxic and flammable. To avoid
injury, wear protective goggles and gloves and use in a well-
ventilated area. Avoid contact with skin, eyes, and clothes, and
do not breathe vapors. Do not use near open fire or excessive
heat. The flash point for Type I dry cleaning solvent is 100F
(38C) and for Type II is 138F (50C). If you become dizzy while
using dry cleaning solvent, get fresh air immediately and get
medical aid. If contact with eyes is made, wash your eyes with
water and get medical aid immediately.
Clean all parts using dry cleaning solvent and clean rags.
62.
NOTE
If either part is
Case and carrier are a matched set.
unserviceable, reassemble final drive, using old parts, tag
unserviceable, and return through supply channels for depot
Case and carrier must be thoroughly cleaned
overhaul.
before inspection.
Using penetrating dye, inspect carrier
63.
(P) and case (Q) for cracks or fractures.
Using crocus cloth, remove minor
64.
scores and burrs from machined
surfaces.
Go on to Sheet 14
7-13
Change 2
