TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 12 of 30)
55.
Using suitable lifting device, position
final drive carrier (P) on two wood
blocks.
56.
Using diagonal cutting pliers, cut and
remove lockwire (AK) from eight bolts (AL).
57.
Using 3/4-inch wrench, loosen bolts
(AL) until heads of bolts touch output
shaft flange (AM).
Using suitable lifting device, carefully
58.
lift output shaft (AJ) while continuing
to loosen bolts (AL).
Lift output shaft (AJ) free of carrier ( P).
59.
NOTE
T O free output shaft (AJ) from
carrier (P), it may be necessary
to tap side of carrier (P) while
lifting output shaft (AJ).
60.
Remove and throw away gasket (AN).
Go on to Sheet 13
7-12 Change 2
