TM 5-5420-202-34
STEERING CONTROL ROD REPLACEMENT (Sheet 2 of 2)
INSPECTION:
1.
Inspect shield for cracks, dents, or warpage.
2.
Inspect steering control rod for bends, breaks, or stripped threads.
INSTALLATION:
NOTE
Make sure end plug (A) is tight and
secure.
1.
Using both hands, screw connector rod (B) into end plug (A) near bulkhead.
2.
Using 5/8 inch wrench at end connector of rod (B) and another 5/8 inch wrench at end
plug (A), tighten rod (B) into end plug (A).
3.
Slide shield (C) over rod (B) so pin near bulkhead fits into slot of shield.
4.
Install support strap (page 10-13).
5.
Install rear connector rod and its cover shield (page 10-13).
6.
Install outer riser link shield at rear of powerplant compartment (TM 5-5420-202-20).
7.
Install left fuel tank (page 4-32).
End of Task
10-11
