TM 5-5420-202-34
REAR STEERING CONTROL ROD REPLACEMENT (Sheet 1 of 3)
TOOLS:
9/16 in. combination box and open end wrench
5/8 in. combination box and open end wrench (2 required)
9/16 in. crowfoot wrench with 3/8 in. drive
Torque wrench with 3/8 in. drive (0-200 lb-in) (0-23 Nm)
TM 5-5420-202-20
REFERENCE:
Remove left fuel tank (page 4-25)
PRELIMINARY
PROCEDURES:
Remove support straps (page 10-12)
Remove outer riser link shield at rear of vehicle (TM 5-
5420-202-20)
REMOVAL:
1.
Using 9/16 inch wrench, loosen jamnut
(A).
Using 9/16 inch wrench, remove self-
2.
locking bolt (B).
Disconnect connector rod end (C) from link.
3.
4.
Using 9/16 inch wrench, remove rod end (C) and jamnut (A).
Pull shield (D) to rear. Pull it off rod (E) toward rear of vehicle.
5.
Using two 5/8 inch wrenches, one to hold front rod while loosening connecting rod at
6.
end connector, remove rear steering control rod (E).
7.
If necessary, remove connecting link assembly (F) (TM 5-5420-202-20).
Go on to Sheet 2
