TM 5-5420-202-34
SUPPORT STEERING CONTROL SHIELD REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
1.
Position support (A) onto plate (B) and install four screws (C) through support (A) and
plate (B).
2.
Position four lockwashers (D) and nuts (E) onto four screws (C).
3.
Using 1/2 inch wrench to hold screws (C), use torque wrench and 1/2 inch socket to tighten
four nuts (E) to 114 lb-in (13 Nm).
4.
Place front shield (F) over rod (G).
5.
Place rear rod (H) and shield (J) in position. Using two 5/8 inch wrenches, connect front
rod (G) and rear rod (H).
6.
Move front shield (F) and rear shield (J) toward front of vehicle under secure.
7.
Position four screws (K) and four lockwashers (L) through straps (M) into supports (A). Use
torque wrench and 1/2 inch socket to tighten four screws (K) to 114 lb-in (13 Nm).
8.
Connect rear control rod to clevis (pages 10-15 and 10-16, steps 5-11).
9.
Install left fuel tank (page 4-3 2).
End of Task
