TM 5-5420-202-34
SUPPORT STEERING CONTROL SHIELD REPLACEMENT (Sheet 1 of 2)
TOOLS:
Torque wrench with 3/8 in. drive
Ratchet with 3/8 in. drive
(0-200 lb-in) (0-23 Nm)
5/8 in. combination box and
1/2 in. combination box and
open end wrench (2 required)
open end wrench
1/2 in. socket with 3/8 in. drive
REFERENCE:
TM 5-5420-202-20
PRELIMINARY
PROCEDURES:
Remove left fuel tank (page 4-25)
Disconnect control rod at rear clevis (page 10-14, steps
1-4)
REMOVAL:
1.
Using 1/2 inch socket, remove four screws (A) and washers (B). Remove straps (C).
2.
Slide shield (D) back approximately two inches toward rear of vehicle.
Using two 5/8 inch wrenches, disconnect rear control rod (E).
3.
Remove shield (D) and control rod (E).
4.
5.
Remove front shield (F) from vehicle.
6.
Using 1/2 inch wrench to hold screw (G), use 1/2 inch socket to remove four nuts (H)
and washers (J) from screws (G).
7.
Remove four screws (G) and two supports
(K) from plates (L).
Go on to Sheet 2
