TM 5-5420-209-12c.ItemtobeInspected/Procedures.This column identifies the general area or specific part where the check or ser-vice is to be done and explains how to do them.d. EquipmentsNotReady/Available.This column lists conditions that make the equipment unavailable for usebecause it is unableto perform its mission, or because it would represent a safety hazard. Do not accept or operate equip-ment with a condition in the “Equipment is Not Ready/Available If” column.NOTEThe terms ready/available and mission capable refer to the same status: Equipment is on hand and isable to perform its combat mission. Refer to DA Pam 738-750.2–9. Reporting Deficiencies. If any problem with the equipment is discovered during PMCS or while it is beingoperated that cannot be corrected at the operator/crew maintenance level, it must be reported. Refer to DA Pam 738-750and report the deficiency using the proper forms.2–10. Special Instructions. Preventive maintenance is not limited to performing the checks and services listed inthe PMCS table.WARNINGDrycleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and property. Avoidrepeated and prolonged skin contact. Do not use near open flame or excessive heat. Flash point of sol-vent is 100°F-138°F (38°C - 60°C).work and as needed. Use drycleaning solvent on all metal surfaces. Use soap and water to clean rubber or plastic materi-al.b. Bolts,Nuts,andScrews.Check them all for obvious looseness, missing, bent, or broken condition. You can’ttry them all with a tool, but look for chipped paint, bare metal, or rust around boltheads. If you find one you think is loose,tighten it, or report it to unit maintenance if you can’t tighten it.c. Electrical Wires and Cable Connectors. Look for bare wires and loose or broken connectors. Report defects tounit maintenance.d. FluidLines. Look for wear, damage, and leaks. Make sure clamps and fittings are tight. Wet spots and stainsaround a fitting or connector can mean a leak. If a leak comes from a loose connector, tighten it. If something is brokenor worn out, report it to unit maintenance.e. LeakageDefinitions.It is necessary for you to know how fluid leakage affects the status of your equipment. Thefollowing are definitions of the types/classes of leakage you need to know to be able to determine the status of your equip-ment. Learn and be familiar with them. When in doubt, NOTIFY YOUR SUPERVISOR!2-18a. KeepItClean.Dirt, grease, oil, and debris get in the way and may cover up a serious problem. Clean as you
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
