TM  5-5420-209-12 Table 2-10. Operator Preventive Maintenance Checks and Services (PMCS) for the Transporter. Location Interval Item To be Inspected Equipment Is Not Item to Procedure Ready/Available  If Service/Check 1 Before Mirror Check mirror configuration. (Should be dual Assembly highway  type). Inspect mirror for cracks and broken glass. Inspect brace, bracket and support arm for cracks,  broken  welds,  deformation  and  loose, broken, or missing  hardware. 2 Before Cab  Step Inspect for cracks, broken welds and jagged Extension protrusions. Filter indicator sight glass must be obstruction free and indicator must be visible in GREEN  band.  Do  not proceed with PMCS if indicator is not  in GREEN band. 3 Before Hydraulic  Filter Check filter indicator position. (Should be in Indicator is NOT in Assembly GREEN  band). green  band. Inspect filter housing for cracks and leakage. Class II or III leak noted. Inspect  lines  for  cracks,  compression  and Class II or III leak noted. leakage. 4 Before Power  Take  Off Check  lever  operation.  (Should  transfer  power Levers do not function (PTO)  Levers to gear pump easily). properly. Inspect  for  deformation. 5 Before Hydraulic Check  valve  operation.  (Valve  should  engage Any valve does NOT Console item  indicated). engage item indicated. Control  Valves Inspect  valves  for  cracks,  leakage  and  loose, Class II or III leak noted. broken  or  missing  hardware. Inspect valves hydraulic lines for compression, Class II or III leak noted. leakage  and  cracks. 6 Before Floodlight Check switch operation. (Should turn on both Master  Switch floodlights). Inspect switch for loose or bare wires. Inspect data plate for legibility. 7 Before Remote Check  throttle  operation.  (Should Throttle increase/decrease  engine  RPM  easily). Assembly Inspect  throttle,  cable  and  retaining  clamps  for (M945) compression, kinks, and deformation. 2-20 Item N o .