TM  5-5420-209-12 Table 2-10. Operator Preventive Maintenance Checks and Services (PMCS) for the Transporter cont. Location Interval   ‘ Item To be Inspected Equipment Is Not Item  to Procedure Ready/Available  If Service/Check 26 Before Cradle Clamp Check clamp position. (Should be stowed beneath pivot bar if not being used for cradle operation). Inspect for cracks, elongation and deformation and loose, broken, or missing hardware. 27 Before Walkway Check clamp position. (Should be snug Clamp against  walkway). Inspect for deformation and loose, broken or missing  hardware. 28 Before Tie Down Hook Check  hook  operation.  (Should  retract  and Hook does not retract or Assembly return easily). return  properly. Check  locking  operation.  (Should  lock  hook Hook  does  not  lock against  tie  down  pin  easily). against  tie  down  pin. Inspect for cracks, broken welds, deformation, and loose, broken, or missing hardware. 29 Before Bay  Roller Check roller rotation. (Should rotate freely). Assembly Inspect roller for gouges, nicks, and cuts to Roller damages bay. surface  area  and  loose,  broken,  or  missing hardware. 30 Before Light,  Marker Check red clearance light and blackout marker and  Reflector operation. Inspect reflector, lenses and housings for cracks,  loose,  broken  or  missing  hardware. Inspect wiring and connectors for cracks or bare  wires. 31 Before Splash  Guards Inspect  guards  for  serviceability. Inspect stiffener for deformation, loose, broken or  missing  hardware. 32 Before Bogie  Lock  and Inspect rubber bumper and metal bracket for Bracket cracks, deformation, dry rot, and loose broken or  missing  hardware. 33 Before Walkway Inspect walkway for cracks, holes, broken Defect   presents welds and jagged protrusions. personnel  or  equipment hazard. 34 Before Bay  Roller Check roller rotation. (Should rotate freely). Assembly Inspect roller for gouges, nicks, and cuts to surface  area  and  loose,  broken,  or  missing hardware. 2-23 Item N  o  .