Bottom Panel to Top and Junction Panels

ASSEMBLE FRONT END OF BRIDGE AND FIRST BAY (DOUBLE STORY)

TM-5-5420-212-10-1 Improved Flaot Bridge Consisting of: Transporter Interior Bay Ramp Bay Manual
Page Navigation
259

ARMY TM 5-5420-212-10-1 MARINE CORPS TM 08676A-10/1-1 b. Bottom Panel to Top and Junction Panels The drill to connect bottom panel to top and junction panels is the same as connecting to top and bottom panels (para. 4-7a.), except there is a headless pin connecting the top and junction panels. A retainer clip must be placed on both ends of the headless pin, after the bottom panel is connected. 4-8. ASSEMBLE FRONT END OF BRIDGE AND FIRST BAY (DOUBLE STORY) a. General This procedure covers the assembly of the bankseat beam, end taper panel, top panels C and B, the junction panel and the first bay top and bottom panels on double story bridges. This assembly is called the front end of bridge (EOB) and first bay. When the end of bridge is to be assembled, the front and rear roller beams will be in position with the longitudinal girders as shown (para. 4-5b.). b. Assembly (1) Ensure both roller beams are level (para. 4-5d.) and that rear roller beam is set lower than front roller beam. (2) Carry the bankseat beam over the low portion of the longitudinal girders and position it close to the FRB. Two personnel steady the bankseat beam during steps (3) and (4). 4-20

Privacy Statement
Press Release
Contact