ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
(5)
Lift bankseat beam onto end taper panels seating the guide pins in the guide pin seats of the end taper
panels.
(6)
Position two personnel on gap side of bankseat beam, and two personnel on each end taper panel. Insert
panel pin in first hole of bankseat beam, do not remove pin once it is started in hole. NCOIC will check gaps
at guide pin and seats and direct crews to move end taper panels and bankseat beam as needed to ensure
bankseat beam is square to end taper panels.
(7)
Connect top panel (C) to bankseat beam.
(8)
Raise the top panels and place a panel pin between the top panels and the end taper panel next to the stop
on the ETP. This acts as packing to ease the installation of the junction panel.
(9)
Connect top panel (B) to (C).
(10) Carry junction panel towards bridge.
(11) Engage dowels and sockets of junction panel and top panel.
(12) When compression faces contact each other, lift the shootbolt and turn handle to the left to lock shoot-bolt.
4-22
