ARMY TM 5-5420-212-10-1 MARINE CORPS TM 08676A-10/1-1 TABLE 5-5.  Delaunch Table - 9 through 12 Bay Single Story (Normal Site) Bridge ft 56 62 68 74 Length m 17.1 18.9 20.7 22.6 Bays 9 10 11 12 L/Nose 5N1 5N1 6N1 6N1 Build Notes a thru e Notes a thru e Notes a thru e Notes a thru e Delaunch 6p5 8p5 7p5 9p5 Remove BSB,9,8,7 BSB,10,9 BSB,11,10,9,8 BSB,12,11,10 Add Note f Note f Note g Note g Delaunch (1p5) (2p4) (1p5) (2p7) Recover LRP LRP LRP LRP Boom 2p0 2p1 Remove 8 9 Boom 1p5 Remove 8 Boom 1p4 1p4 1p4 Remove 7 6N1,7 6N1,7 Boom 1p2 1p2 1p2 1p2 Remove 5N1,4N1,3N1 5N1,4N1,3N1 5N1,4N1,3N1 5N1,4N1,3N1 6 6 6 6 2N1,5 2N1,5 2N1,5 2N1,5 1N1, LLN 1N1, LLN 1N1,LLN 1N1,LLN 4 4 4 4 Note h Note h Note h Note h 3 3 3 3 Boom BSB BSB BSB BSB Note i Note i Note i Note i Remove 2,1 2,1 2,1 2,1 Complete By Note j Note j Note j Note j NOTES: a. Remove curbs, deck units and ramps. b. Install  RB  under  bridge  minimum  1.5  ft  (0.5m)  from  end.    If  minimum  bearing  is  being  used,  position  RB under center hole of BSB. c. Position center of LR (in LRP) 8 ft (2.4 m) from BSB. d. Position BP as required to keep bridge off ground. e. Add LNCG posts, LNCG, nose roller and 3 LNH.  Reposition LRP [base 9 in (23 cm) from BSB].  Add LNH 4. f. Add LNH5 and LLN. g. Add LNH5, LNH6 and LLN. h. Move BP to 2p7.  Remove nose roller, LNCG and LNCG posts. i. Move BP to lp7 j. Remove BSB.  Clear site. ( ) Center of gravity. 5-7