ARMY TM 5-5420-212-10-1MARINE CORPS TM 08676A-10/1-15-17. PICKET TYPE INSTALLATIONBefore ramps are added, Install pickets as follows:-(1)Use hammer to drive pickets into bank at 1 ft (0.3 m) intervals along the outside end of near bankseatbeam.5-18. APPROACH GUY INSTALLATIONDuring construction, anchorage pins will be used in place of panel pins, as described in the following steps. Theseprocedures are written for the use of two or four cables at each end of bridge. Step (7) can be performed immediatelyafter arrival on site, depending on the availability of personnel.Installation(1)Insert far bank anchorage pins, instead of panel pins, in junction of first and second bay. Anchorage pinmust be inserted from inside of bridge.NOTEBridge must be boomed until anchorage pin Is In front of roller beam before anchorage lug can beattached.5-47
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
