ARMY TM 5-5420-212-10-1 MARINE CORPS TM 08676A-10/1-1 TABLE 7-5.  (cont’d) Delaunch Table - 2E + 13 through 2E + 17 Bay Link Reinforced (Normal Site - Original Far Bank) Bridge ft 108 114 120 126 132 Length m 32.9 34.8 36.6 38.4 40.2 2E+No.  Bays 13 14 15 16 17 L/Nose 7N1 7N1 7N1 8N1 8N1 V Distance ft 118.6 124.9 129.1 136.7 142.6 m 36.16 38.06 39.36 41.66 43.46 Boom 1p7 lp7 1p7 1p7 lp7 Remove TP7,BP6,7N1 TP7,BP6,7N1 TP7,BP6,7N1 TP8,BP7,8N1 TP8,BP7,8N1 TP6,BP5 TP6,BP5 TP6,BP5 TP7,BP6,7N1 TP7,BP6,7N1 TP5,BP4,6N1* TP5,BP4,6N1* TP5,BP4,6N1* TP6,BP4,6N1* TP6,BP4,6N1* Boom 2p0 2p0 2p0 2p0 2p0 Remove Pin at A Pin at A Pin at A Pin at A Pin at A Boom 1p4 1p4 1p4 1p4 1p4 Remove TP4,BP3 TP4,BP3 TP4,BP3 TP4,BP3 TP4,BP3 TP3,BP2 TP3,BP2 TP3,BP2 TP3,BP2 TP3,BP2 Boom Bp0 Bp0 Bp0 Bp0 Bp0 Remove TP2,1 TP2,1 TP2,1 TP2,1 TP2,1 Boom Bp2 Bp2 Bp2 Bp2 Bp2 Remove E E E E E Complete by: Note i Note i Note i Note i Note i NOTES: a. Remove curbs, ramps and deck units. b. Skid bridge to correct bearing. c. Position ex FRB under bridge 3 ft (0.9 m) from new A’ peg.  Bridge should overhang ex FRB min.  1.5 ft (0.5 m) d. Position CRB next to ex FRB. e. Add LNCG posts, LNCG, nose roller and install launching nose, then reposition LRP 12 ft from A peg. f. Delaunch bridge until far BSB is 6 ft (1.8 m) from A peg or end of ETP overhangs CRB by minimum 1.5 ft (0.5 m) g. Reposition LRP against new A peg and then remove ex.  FRB. h. Stop  boom/delaunch  to  remove  long  or  short  links,  light  tackle,  anti-flutter  and  add  launching  noses  as required, observing minimum 5 ft (1.5 m) overhang. i. Disassemble FRB and RRB.  Clear site. * Remove entire launching nose, LNCG, LNCG posts and nose roller. ( ) Center of gravity. 7-11