ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
8-19 PULLER
This task covers:
a.
Removal
c.
Inspection
e.
Pre-Load Check of Bearing
INITIAL SETUP:
Materials Required
Heavy gear oil (21, Appendix D)
Cleaning solvent (22, Appendix D)
Suitable bath
Protective gloves
Protective goggles
Clean cloths
Equipment Conditions
Puller removed from post tensioning assembly, or jacking bracket.
Service
(1)
Inspect for damage, cracks, corrosion, bent or broken parts. If there is any doubt about serviceability of
puller, make a full report on condition to Unit Maintenance.
(2)
Remove any caked on mud etc. from casing (1) and slot (2).
WARNING
Wear protective gloves and goggles. Cleaning solvent Is toxic and flammable. Use only In a well
ventilated area. Avoid breathing the fumes, and skin contact. Do not use in excessive amounts,
and keep away from flames.
(3)
Place puller in bath of cleaning solvent and allow to soak for an hour.
8-38
