TM 5-5420-226-20-2
TRANSMISSION MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 4 of 4)
3.
Using pliers, install safety wire (D)
between bushing (C) and bracket (A).
4.
Remove from vise and position bracket
(A) onto transmission and using 3/4
inch socket and ratchet, install three
screws (E) and washers (F) through
mount on transmission into bracket
(A). Leave screws loose.
Position spacer (G) into bracket (A) and install
5.
bolt (H), through spacer (G), mount
(A), and washer (J).
With second man using 1-1/2 inch open end
6.
wrench to hold bolt (H), use 1-1/2 inch socket
and torque wrench to tighten nut (K) to 380
to 415 lb-ft (515-562 Nm).
7.
Position roller (L) onto screw (M) and install
screw (M) through bracket (A).
8.
Using 1/2 inch square drive bit screwdriver
and 1/2 inch drive ratchet to hold screw (M),
use 1 1/4 inch open end wrench to install
nut (N) onto screw (M).
NOTE
It may be necessary to turn universal to
gain access to screw (E).
Using torque wrench and 3/4 inch socket, tighten
9.
screws (E) to 70-75 lb-ft (95-101 Nm).
10.
Install powerplant (page 5-14).
TA107481
End of Task
6-11