TM 5-5420-226-20-2
ENGINE OIL COOLER FLUID PUMP CONNECTOR REPLACEMENT (Sheet 3 of 4)
10.
Remove and discard gasket (K) under
connector (G).
CLEANING AND INSPECTION:
1.
Using solvent clean hose (E) and connector
(G) .
2.
Replace connector (G) if cracked or
broken.
Inspect threads on hose (E) and connector
3.
(G). Replace as required.
Replace hose (E) if woven shielding
4.
is worn or broken.
INSTALLATION:
1.
Position new gasket (A) on oil cooler
(B).
Position connector (C) over gasket
2.
(A).
3.
Using 1/2 inch wrench, install three
new nuts (D).
4.
Using 1-1/2 inch wrench install hose
(E) to connector (C).
TA107528
Go on to Sheet 4