TM 5-5420-226-20-2
ENGINE OIL COOLER FLUID PUMP CONNECTOR REPLACEMENT (Sheet 1 of 4)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Cleaning and Inspection
Installation
T O O L S:
9/16 in. combination box and open end wrench
1/2 in. combination box and open end wrench
3/8 in. combination box and open end wrench
1-1/2 in. combination box and open end wrench
3/4 in. combination box and open end wrench
Flat-tip screwdriver
Torque wrench with 1/2 in. drive, 0-200 lb-in cap.
3/4 in. socket with 1/2 in. drive
SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section 1)
Dry cleaning solvent
SUPPLIES:
Rags (Item 12, Appendix D)
Gasket 8682679
Washer NAS1598-6V
Nuts MS21044N5 (3 required)
Lubricating oil (Item 44, Appendix D)
REFERENCES:
Remove powerplant (page 5-2)
PRELIMINARY PROCEDURE:
TA107526
Go on to Sheet 2
